@article{gu_gong_dilip_pal_hicks_doak_stucker_2015, title={Effects of powder variation on the microstructure and tensile strength of Ti-6Al-4V parts fabricated by selective laser melting}, volume={51}, number={1}, journal={International Journal of Powder Metallurgy}, author={Gu, H. F. and Gong, H. J. and Dilip, J. J. S. and Pal, D. and Hicks, A. and Doak, H. and Stucker, B.}, year={2015}, pages={35–42} }
 @article{gong_rafi_gu_ram_starr_stucker_2015, title={Influence of defects on mechanical properties of Ti-6Al-4 V components produced by selective laser melting and electron beam melting}, volume={86}, ISSN={["1873-4197"]}, DOI={10.1016/j.matdes.2015.07.147}, abstractNote={This study evaluates the mechanical properties of Ti–6Al–4 V samples produced by selective laser melting (SLM) and electron beam melting (EBM). Different combinations of process parameters with varying energy density levels were utilized to produce samples, which were analyzed for defects and subjected to hardness, tensile, and fatigue tests. In SLM samples, small pores in amounts up to 1 vol.% resulting from an increase in energy density beyond the optimum level were found to have no major detrimental effect on the mechanical properties. However, further increase in the energy density increased the amount of porosity to 5 vol.%, leading to considerable drop in tensile properties. Samples produced using lower-than-optimum energy density exhibited unmelted powder defects, which, even at 1 vol.% level, strongly affected both tensile and fatigue properties. In EBM, insufficient energy input was found to result in large, macroscopic voids, causing serious degradation in all mechanical properties. These findings are helpful in process optimization and standardization of SLM and EBM processes.}, journal={MATERIALS & DESIGN}, author={Gong, Haijun and Rafi, Khalid and Gu, Hengfeng and Ram, G. D. Janaki and Starr, Thomas and Stucker, Brent}, year={2015}, month={Dec}, pages={545–554} }