Mechanical and Aerospace Engineering

Feedback control of a space vehicle with unactuated fuel slosh dynamics

AIAA Guidance, Navigation, and Control Conference and Exhibit. Presented at the AIAA Guidance, Navigation, and Control Conference and Exhibit.

Heat generation during the fatigue of a cellular Al alloy

Metallurgical and Materials Transactions A, 31(4), 1129–1136.

A study on fracture behavior of particle reinforced metal matrix composites by using acoustic emission source characterization

Materials Science and Engineering: A, 293(1-2), 81–87.

Failure mechanisms associated with the thermally grown oxide in plasma-sprayed thermal barrier coatings

Acta Materialia, 48(15), 3963–3976.

Soot formation effects of oxygen concentration in the oxidizer stream of laminar coannular nonpremixed methane/air flames

COMBUSTION AND FLAME, 121(1-2), 323–333.

Relative effect of acetylene and PAHs addition on soot formation in laminar diffusion flames of methane with oxygen and oxygen-enriched air

COMBUSTION AND FLAME, 122(1-2), 76–89.

Chemical structures of methane-air filtration combustion waves for fuel-lean and fuel-rich conditions

PROCEEDINGS OF THE COMBUSTION INSTITUTE, Vol. 28, pp. 1431–1438.

The law of large numbers for fuzzy numbers with unbounded supports

FUZZY SETS AND SYSTEMS, 116(2), 269–274.

Partially premixed combustion in lifted turbulent jets

COMBUSTION SCIENCE AND TECHNOLOGY, 156, 97–105.

Numerical simulation of a three-dimensional flame/shock wave interaction

Roy, C. J., & Edwards, JR. (2000, May). AIAA JOURNAL, Vol. 38, pp. 745–754.

Simultaneous particle-imaging velocimetry and OH planar laser-induced fluorescence measurements in an unsteady counterflow propane/air diffusion flame

PROCEEDINGS OF THE COMBUSTION INSTITUTE, Vol. 28, pp. 2021–2027.

Turbulent three-dimensional air flow and trace gas distribution in an inhalation test chamber

Longest, P. W., Kleinstreuer, C., & Kinsey, J. S. (2000, June). JOURNAL OF FLUIDS ENGINEERING-TRANSACTIONS OF THE ASME, Vol. 122, pp. 403–411.

An experimental investigation of the creping process in low-density paper manufacturing

JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING-TRANSACTIONS OF THE ASME, 122(3), 576–581.

r-Refinement grid adaptation algorithms and issues

COMPUTER METHODS IN APPLIED MECHANICS AND ENGINEERING, 189(4), 1161–1182.

Using computer spreadsheets for water flow and biofilter sizing in recirculating aquaculture production systems

Losordo, T. M., & Hobbs, A. O. (2000, September). AQUACULTURAL ENGINEERING, Vol. 23, pp. 95–102.

Simulation of coupled turbulent flow and heat transfer in the wedge-shaped pool of a twin-roll strip casting process

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 43(20), 3811–3822.

High strain-rate shear-strain localization in f.c.c. crystalline materials: a perturbation analysis

INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES, 37(43), 6177–6202.

Determination and representation of the stress coefficient terms by path-independent integrals in anisotropic cracked solids

INTERNATIONAL JOURNAL OF FRACTURE, 101(4), 291–319.

Anti-windup controller design using linear parameter-varying control methods

INTERNATIONAL JOURNAL OF CONTROL, 73(12), 1104–1114.

Transient flow field effects on soot volume fraction in diffusion flames

COMBUSTION SCIENCE AND TECHNOLOGY, 160, 165–189.