@article{duke_mirka_sommerich_2004, title={Productivity and ergonomic investigation of bent-handle pliers}, volume={46}, ISSN={["1547-8181"]}, DOI={10.1518/hfes.46.2.234.37341}, abstractNote={ Awkward wrist posture is generally considered an occupational risk factor for hand/wrist disorders, leading to the ergonomic design principle of “bend the tool, not the wrist.” Sixteen participants performed a computer jumper installation task and a simple assembly task while productivity, wrist posture, and shoulder posture were measured. The work surface orientation (vertical and 45°) and the level of constraint placed on the user (constrained grip and unconstrained grip) were also varied. The results indicate that the beneficial effects of the bent-handle pliers are task dependent. In the computer jumper task the bent-handle pliers resulted in 5.3% faster task performance, whereas in the assembly task performance was 4.9% faster with the straight-handle pliers. The bent-handle pliers reduced shoulder deviations by 50% in the jumper installation task, and ulnar deviation was reduced by 12% and 22% for the jumper installation task and the assembly task, respectively (all significant at p < .05). However, allowing participants to hold the pliers in a grip configuration of their choosing (unconstrained technique) often reduced these postural benefits. In applying these results to work place design activities, one should recognize that the ergonomic utility of benthandle pliers can be considerable but that the 3-D kinematics characteristics of the task must be considered. }, number={2}, journal={HUMAN FACTORS}, author={Duke, K and Mirka, GA and Sommerich, CM}, year={2004}, pages={234–243} }